- At least 1 LED Strip on dataport LED_PIN
- Microphone MIC_PIN
- Button on BUTTON_PIN
- Neopixel Ring on RING_PIN (Optional)
- Color Sensor (Optional)
Turn Flora on to start with the first animation. The first animation is sound reactive.
-
Click once to move to the next animation. The animations evolve from low energy and mellow to more and more intense.
-
Double-click to reset to the first animation.
-
Double-click again to change its palette (will rotate through palettes)
-
Hold the button down to get the animation to prepare for a peak. It will go up and up until you release
-
Release after long press to activate the peak. It will go on until you click again
-
Triple-click to go to settings mode
The settings mode currently allows to set the brightness for the whole program. The brightness is broken down in 10 increments. The strip will use the entire strip as a progress bar. Click to increase brightness by 255/10 until it starts over to the minimum (Minimum is 25). Long press to save changes and go back to animation mode!
3D Printed in NinjaFlex Semi-Transparent Filament with Makerbot Replicator 2. Can publish the models on Thingiverse if needed.
A lot of this code is based on the outstanding work of Mark Kriegsman and its fantastic library FastLED, as well as some from Andrew Tuline.
