Update SDL2 Information

config.ini.sample

@@ -8,12 +8,12 @@
 fullscreen=true
 ; set this to false to run m8c in software rendering mode (may be useful for Raspberry Pi)
 use_gpu=true
+; set this to true to disable the mouse cursor at startup
+diable_cursor=true
 ; the delay amount in ms in the main loop, decrease value for faster operation, increase value if too much cpu usage
 idle_ms = 10
 ; show a spinning cube if device is not inserted
 wait_for_device = true
-; set this to true to disable the mouse cursor at startup
-diable_cursor=true
 ; number of zero-byte attempts to disconnect if wait_for_device = false (128 = about 2 sec for default idle_ms)
 wait_packets = 128
 
@@ -24,7 +24,7 @@ audio_device_name=Default
 
 [keyboard]
 ; these need to be the decimal value of the SDL scancodes.
-; a table exists here: https://github.com/libsdl-org/sdlwiki/blob/main/SDLScancodeLookup.mediawiki
+; a table exists here: https://github.com/libsdl-org/sdlwiki/blob/main/SDL2/SDLScancodeLookup.mediawiki
 key_up=82
 key_left=80
 key_down=81