KlipperScreen.conf

#load = False

#~# --- Do not edit below this line. This section is auto generated --- #~#
#~#
#~# [main]
#~# use_dpms = False
#~# 
#~# [displayed_macros Printer]
#~# activate_probe = False
#~# adaptive_bed_mesh = False
#~# bedfans_fast = False
#~# bedfans_off = False
#~# clear_active_spool = False
#~# bedfans_slow = False
#~# dump_parameter = False
#~# dump_print_area_limits = False
#~# dump_parameters = False
#~# dump_warnings = False
#~# compute_mesh_parameters = False
#~# g01 = False
#~# g00 = False
#~# g02 = False
#~# g03 = False
#~# g04 = False
#~# deactivate_probe = False
#~# m125 = False
#~# m205 = False
#~# m600 = False
#~# m601 = False
#~# m701 = False
#~# rst_filter_hepa = False
#~# restart_camera = False
#~# rst_service = False
#~# rst_filter_media = False
#~# m702 = False
#~# m900 = False
#~# end_print = False
#~# set_active_spool = False
#~# search_vars = False
#~# status_leds = False
#~# start_print = False
#~# start_filter = False
#~# stop_filter = False
#~# park_rear_left = False
#~# park_rear_right = False
#~# heatsoak_chamber = False
#~# heatsoak_bed = False
#~# backup_cfg = False
#~# git_backup_cfg = False
#~#